New products
New products
zł103.20
Delivery date unknown
zł245.27
6 weeks
zł256.05
6 weeks
zł264.82
6 weeks
Available
Nova PM100 laser particle sensor
ID: 577483
5906623457427
zł435.31
Tax included
zł353.91 tax excl.
Total suspended particulate (TSP) sensor that allows you to measure the particle concentration from 1 to 100 μm. SDS198
Description
Total suspended particulate (TSP) sensor, using principle of laser scattering, can get the particle concentration between 1 to 100μm in the air. The sensor can communicate with the microcontroller via the UART interface or via a configurable output port. The laser diode used in the sensor is of high quality and allows trouble-free operation even for 8000 hours of continuous working, this time can be significantly extended by reducing the frequency of measurements.
Pin connections
| No. | Name | Comment |
| 1 | NC | Not Connect |
| 2 | 1μm | Reserved |
| 3 | 5V | 5V Input |
| 4 | 2,5μm | Reserved |
| 5 | GND | Ground |
| 6 | R | RX interface UART（TTL）@3.3V |
| 7 | T | TX interface UART（TTL）@3.3V |
Features
- Measuring range: 0-20 mg / m3
- Measurement sensitivity: 1 μg / m3
- Working voltage: 5V
- Logical voltage of the UART interface: 3.3 V
- Current consumption: 70 mA ± 10 mA
- Power consumption in standby mode: <4mA
- Working temperature: -10 ~ +50 ℃
- Storage temperature: -20 ~ +60 ℃
- Maximum working humidity: 70%
- Maximum storage humidity: 90%
- Maximum relative error: ± 20% ± 30 μg / m3
- Supply voltage: 4.7 - 5.3 V
- Dimensions: 71 x 70 x 23 mm
- Compliance with certificates: CE, FCC, RoHS
577483
Data sheet
- Interface
- UART
- Type of sensor
- inny
- Power supply voltage
- 5 V
- Concentration measurement
- PM1 - PM100
Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland [email protected] 22 767 36 20
You might also like
Board with Atmel ATmega328 microcontroller from the AVR family, there are 14 I / O lines, 6 PWM channels and 6 analog inputs. The additional ATmega16U4 microcontroller realizes communication via the USB interface
zł55.78
Delivery date unknown
No product available!
Arduino Uno Rev3 is a popular board with Atmel ATmega328 microcontroller from the AVR family, there are 14 I / O lines, 6 PWM channels and 6 analog inputs. The additional ATmega16U4 microcontroller realizes communication via the USB interface. Arduino A000066
zł108.42
24h
Available quantity: 198
Available
The latest version of the Raspberry Pi series: Raspberry Pi 4 model B with quad-core SoC (Broadcom BCM2711, Cortex-A72) working at 1.5GHz, 2GB RAM LPDDR4, Broadcom VideoCore VI.
zł220.99
24h
Available quantity: 132
Available
The long-awaited Raspberry Pi 4 model B with the SoC Broadcom BCM2711 SoC (4 x Cortex-A72) running at 1.5GHz, 4 GB LPDDR4 RAM and the Broadcom VideoCore VI graphics chip
zł277.00
24h
Available quantity: 144
Available
Development board with SAMD21 microcontroller (ARM Cortex® M0+), 8 I/O lines, 12 PWM channels, micro-USB. The board is equipped with an ESP32 module enabling the implementation of communication via WiFi. Arduino MKR WiFi 1010 ABX00023
zł178.01
24h
Available quantity: 2
Available
Board with nRF52840 microcontroller with Cortex M4F core (64 MHz, 1 MB Flash, 256 kB RAM). Equipped with BT 5.0 and IMU LSM9DS1 module. Module with headers. Arduino ABX00034
zł179.00
24h
Available quantity: 24
Available
Other products in the same category (16)
Module with environmental sensors for Raspberry Pi Pico. It allows you to measure temperature, humidity, air quality pressure and color detection. SB Components 22366
zł208.80
24h
Available quantity: 3
Available
Air quality sensor module based on the ENS160 system. It communicates via the I2C interface (Gravity connector). DFRobot SEN0514
zł97.10
24h
Available quantity: 3
Available
A sensor used to detect air pollutants by measuring VOCs and gases such as ammonia or hydrogen sulfide. It is used in various areas, such as the food industry, chemical industry, air quality control in laboratories and environmental monitoring. Figaro TGS2602
zł31.33
6 weeks
No product available!
Laser sensor of air pollution with particles PM1,0, PM2.5 and PM10. It allows for precise analysis of the amount of pollutants in the environment, has small dimensions and a built-in silent transfer fan. Data is output to the UART interface. PMS3003
zł95.25
24h
Available quantity: 40
Available
Module with sensors of environmental parameters. It allows you to measure temperature, humidity and pressure as well as CO2 and VOC concentration. DFRobot SEN0335
zł136.19
24h
Available quantity: 2
Available
The RRH62000-A1V is an integrated air quality sensor module by Renesas, combining the measurement of particulate matter (PM1, PM2.5, PM10), volatile organic compounds (TVOC), estimated carbon dioxide levels (eCO₂), temperature, and humidity in a single device.
zł179.00
24h
Available quantity: 3
Available
Air quality sensor based on the ENS160 chip and enclosed in a housing. It communicates via an I2C interface. DFRobot SEN0515
zł158.12
24h
Available quantity: 1
Available
Air quality sensor module PMSA003I. It allows for a precise analysis of the amount of pollutants in the environment based on the concentration of PM1.0, PM2.5 and PM10 particles. Adafruit 4632
zł232.83
24h
Available quantity: 2
Available
Laser sensor of air pollution with PM2,5 and PM10 particles. It allows for precise analysis of the amount of pollutants in the environment, has small dimensions and a built-in silent transfer fan. The data is output to the UART interface and via the PWM signal. Nova Fitness SDS018
zł147.14
24h
Available quantity: 2
Available
SenseCAP CO2, Temperature and Humidity Sensor - CO2, temperature and humidity sensor with RS485 &...
Digital sensor dedicated to measuring carbon dioxide (CO2), air temperature and relative humidity. High performance, fast response and excellent stability make it an ideal solution for a variety of applications such as greenhouses, cities, poultry farms and transport stations. Seeed Studio 101991029
zł579.43
24h
Available quantity: 3
Available
Module with PM2.5 dust sensor. The board is equipped with a Gravity connector and communicates via the I2C interface. DFRobot SEN0460
zł202.34
24h
Available quantity: 1
Available
ENS160 gas sensor module to measure the concentration of carbon dioxide (eCO2) and volatile organic compounds (TVOC) in the air. It communicates via an I2C or SPI interface. SparkFun SEN-20844
zł119.84
24h
Available quantity: 3
Available
BME680 integrated gas, pressure, temperature and humidity sensor module housed in a single MEMS housing. It is equipped with an I2C and SPI interface. Waveshare BME680 Environmental Sensor
zł63.84
24h
Available quantity: 5
Available
BME688 integrated gas, pressure, temperature and humidity sensor module in a single MEMS housing. It is equipped with an I2C and SPI interface. It has built-in AI functions. Waveshare BME688 Environmental Sensor
zł102.93
24h
Available quantity: 2
Available
BME688 integrated gas, pressure, temperature and humidity sensor module housed in a single MEMS package. It features a Grove connector and communicates via an I2C or SPI interface. Seeed Studio 114992989
zł172.86
24h
Available quantity: 1
Available
Module dedicated to projects related to air quality monitoring. It uses the popular ENS160 and BME280 chips and provides a variety of environmental data such as Air Quality Index (AQI), TVOCs levels, CO2 equivalent (eCO2), atmospheric pressure, humidity and temperature. It communicates via the I2C interface and offers two Qwiic connectors. SparkFun SEN-22858
zł153.10
24h
Available quantity: 1
Available
Total suspended particulate (TSP) sensor that allows you to measure the particle concentration from 1 to 100 μm. SDS198