

Adapter from HDMI to VGA, length 15 cm.
The adapter is compatible with Raspberry Pi 3/2 / B + / B
Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland [email protected] 22 767 36 20
Adapter from HDMI to VGA with microUSB power input and 3.5mm audio jack, 15cm
VGA cable, 1.8 m long, with a ferrite filter, is used to connect devices with a VGA (D-Sub) connector and is compatible with many standards, including HD and Full HD. Akyga AK-AV-01
8-channel IO expander with 6 analog inputs. It communicates via the USB interface. Version without Pull-Up resistors. Numato Lab GP80001
Adafruit 583 - EL wire starter pack - Blue 2.5 meter (8.2 ft)
No product available!
LED strip with addressable RGB WS2813 diodes on a white PCB. It is powered by 5 V DC, has a length of 5 m and 60 LEDs/m. Protection degree IP67
No product available!
Mini module with ToF VL53L5CX sensor with a matrix of 64 pixels and a range of up to 4 m. It is equipped with a Qwiic connector and communicates via the I2C interface. SparkFun SEN-19013
Gravity: Formaldehyde (HCHO) Sensor is a module for measuring the concentration of formaldehyde (methane) in the air. It can be supplied with voltage in the range of 3.3 ... 6V. DFRobot SEN0231
The SMA male crimp connector for cable is a standard connector used in a wide range of radiocommunication and electronic devices. It is made of anodized brass. It has an impedance of 50 Ω, which is a standard parameter for many radio communication systems
RGB LED WS2812B 8 x 4 matrix module for Raspberry Pi, one signal pin, additional power connector, direct RPI computer overlay. Waveshare RGB LED HAT
LPC55S26JBD64K, ARM Cortex-M33 Microcontroller, 32 bit, 150 MHz, 256 KB Flash, HTQFP-64
Module with a button and red LED backlight. The board is equipped with a Gravity connector and communicates via a digital interface. DFRobot DFR0785-R
Female terminal block, 8-pin. Pitch 5.0mm. Height 15mm. 2EDGK-5.0-8P
Voltage converter module with a symmetrical output of ± 15 V with a maximum power of 150 W. Used, among others, to power audio amplifiers
STM8S 8-bit MCU, 128K Flash, 6K RAM, 2K EEPROM, LQFP80, RoHS
4-channel module with relays designed to work with the Raspberry Pi Pico. It can switch signals up to 250 V AC and 7 A or 30 V DC and 10 A. SB Components 21178
Flex Cable for Raspberry Pi Camera - 100mm / 4"
A connector that allows you to connect the cable to the existing installation without having to cut the cable. Suitable for wires with a cross-section of 0.5-1.5mm2
Adapter from HDMI to VGA, 15cm